Detector, fire smoke sensor SPD-2 Tiras Ex (СПД-2 Тірас Ex) point intrinsically safe 2-wire, designed to detect fires in their early stage in closed premises of buildings and structures, power supply 8-30 V, HP.Mounted on the ceiling. Designed for an..
The detector, fire smoke detector IPK-8 is designed to detect a fire in a protected area, 2-wire connection, supply voltage (10-30) V.The functioning of the detector is based on the principle of controlling the scattering of radiation by smoke partic..
The remote optical signaling device TIRAS VPOS is designed for external indication of the activation of the detector, which is located behind the suspended ceiling or in another inaccessible place.The VPOS is connected to all fire detectors of the "T..
Manual fire alarm IPR-1 IP54 for indoor and outdoor installation, degree of protection IP54. The inclusion of detectors in the fire alarm loop is carried out according to the loop current increase scheme. The switching current is 20 mA, the voltage i..
Fire thermal sensor IPK-9 maximum, 2-wire connection, power supply voltage (10-30), designed to detect ignition sources accompanied by an increase in ambient temperature. Maximum detectors should preferably be installed in rooms where neither smoke d..
Внешнее устройство оптической сигнализации ЗПОС (ВУОС) предназначено для дублирования оптической сигнализации и может быть подключено к пожарным извещателям, имеющим соответствующие выходы. Индикация осуществляется светодиодным индикатором красного ц..
Fire detector ARTON SPD-3 (СПД-3) smoke 2-wire, supply voltage range 10÷30V, consumption current in duty mode ≤ 95 μA, optical indication of duty mode; Ø95x48mm.Features:• 2-wire connection to the control panel• Indication of the next working mode an..
Fire sensor ARTON SPD-3.4 (АРТОН СПД-3.4) autonomous smoke on batteries is designed to detect fires accompanied by the appearance of smoke and issue sound and light fire warning signals.Features:• Powered by a 9 V Krone type battery• "Test/Reset" but..
Fire detector ARTON SPT-3B-NZ thermal 4-wire with normally closed relay contacts. It is designed to monitor the ambient temperature exceeding the set value in closed rooms.Features:• Maximum differential (A2R class)• Static operating temperature rang..
Detector, manual fire detector SPR-1, new design, type A.Features:• Formation of the "Fire" signal by both decreasing and increasing the current of the SHS• Activation by means of a button• Reinstallation with a recovery key• 2-wire, powered by a 12/..
The detector, thermal fire sensor IPK-7 PREMIER maximum differential microprocessor is designed to detect a fire in a protected room, 2-wire connection, supply voltage (10-30) V.The detector consists of a fast temperature/voltage converter and a micr..
Извещатель, датчик пожарный СП-2.1 400 дымовой оптический предназначен для для обнаружения загораний, сопровождающихся появлением дыма и выдачи звуковых и световых сигналов оповещения о пожаре, обеспечивает одновременный контроль пространств за подве..
Извещатель пожарный ручной ИПР-1-Ех взрывозащищенный для установки внутри помещений и для наружного применения. Включение извещателей в шлейф пожарной сигнализации производится по схеме увеличения тока шлейфа. Ток коммутации - 20 мА, напряжение до 30..
Thermal fire sensor IPK-9-Ex (ИПК-9-Ех) thermal maximum explosion-proof, 2-wire connection, power supply voltage (10-30), designed to detect ignition sources, accompanied by an increase in ambient temperature. Maximum detectors should preferably be i..
The TIRAS SPR-A (СПР-А) fire detector is intended for giving a fire alarm signal in manual mode.SPR-A is intended for manual transmission of a fire alarm notification to the control panel through the address loop of the alarm system. Features:•..
The ARTON SPD-3.2 smoke optical point fire detector is designed to detect fires in closed rooms of various buildings and structures, which are accompanied by the appearance of smoke and the transmission of the "FIRE" signal to the control panel. The ..
Manual fire detector IPR-1 version 1 with a transparent cover, switching current up to 20 mA, voltage up to 30 V, without LED indication. The overall dimensions of the detector are 90x93x48 mm. The total weight is 0.2 kg.Characteristics:• The detecto..
Detector, SPD-3.10 B01 fire optical smoke detector, designed to detect fires in closed rooms of various buildings and structures, accompanied by the appearance of smoke and transmission of the "FIRE" signal to the control panel. Base B01.The detector..
ARTON SPR-3L manual fire detector, which creates an alarm state in the event of a sharp increase in current consumption; "Fire" state indication; "Standby mode". Additional terminals for connecting AL wires, terminating and limiting resistors.Feature..
Gas leak detector Jablotron JS-133 methane, propane, butane analyzer. The GS-133 gas detector detects the presence of gases in the air (natural gas - methane, propane, butane, acetylene, etc.). The detector detects two levels of gas concentration, pr..
Fire smoke detector IPK-8/1 (ИПК-8/1) is designed to detect a fire in a protected room, 4-wire connection, supply voltage (10-30) V, scattered radiation with relay normally closed output.The functioning of the detector is based on the principle of co..
The ARTON SPD-3.10 B2 (СПД-3.10 Б2) smoke optical 4-wire fire detector is designed to detect fires in closed rooms of various buildings and structures, which are accompanied by the appearance of smoke and the transmission of the "FIRE" signal to the ..
Detector, fire smoke optical sensor IPK-4 PREMIER (ИПК-4 ПРЕМ`ЄР) microprocessor with digital signal processing and remote control, automatic dust compensation, exceptional resistance to interference, self-testing, designed to detect fire in a p..